Install Main Cable - Pacific Zuma Assembly And Maintenance Manual

Zuma Assembly and Maintenance Guide

8. Install Main Cable

A. From the back of the machine, pass the Main Cable
40509-102 connected to the Selector Stem over
one 4½-inch pulley.
B. Attach the pulley to the Guide Rod Arm of the Top
Beam as shown using
one 2-inch bolt
two washers
one locknut
Wrench tighten.
C. Feed the Main Cable into the bottom hole of the
Pulley Support Tube and out the top. Then, feed the
Cable through the window in the Main Upright and
allow it to hang freely.
While this cabling may look strange, it will make
sense later.
D. Wrap the Main Cable over one 3½-inch pulley and
mount the pulley in the top of the Pulley Support
Tube using
one 2¾-inch bolt
two ½-inch step spacers
one locknut
Wrench tighten.
Step 8. Install Main Cable
Main Cable
Ab Cable
Lower Cable
1 2 3
1 - 4½" pulley
1 - 2" bolt
B
2 - washers
1 - locknut
Guide Rod
Arm of the
Top Beam
A
C
Guide Rods
Top Beam
1 - 3½" pulley
D
1 - 2¾" bolt
2 - ½" step spacers
1 - locknut
Main Upright
4 5
Pulley Support
Tube
6
page 17