Install Guide Rods - Pacific Zuma Assembly And Maintenance Manual

Zuma Assembly and Maintenance Guide

3. Install Guide Rods

A. Place the Guide Rods into the two holes in the
Main Base. Until step 4 (when you attach them to
the Top Beam), the Guide Rods will lean away from
the base; however, they will not fall out.
Use care not to get lubricant from the rods on your
clothing or on other parts of the machine.
B. Place one Guide Rod Spacer and one Weight
Cushion on each Guide Rod and allow it to slide
down to the top of the Main Base.
C. Add the fifteen 10-lb weights. Note the tab location
for the weight decals (you will attach the decals
later). Hold your finger over the plastic bushing in
each weight to prevent the bushing from popping
out.
CAUTION: The weights are heavy! Handle the
weights carefully so as not to drop them or
injure yourself. Pick up and place one weight at
a time on the Guide Rods. Have someone hold
the Guide Rods in place while you slide the
weights on the stack.
D. Place the Top Cap Weight on the Guide Rods with
the hole facing toward you. Allow it to slide to the
weight stack.
Step 3. Install Guide Rods
Main Upright
Holes in the
Main Base
1 2
15 - 10-lb Weights
3 4 5
Guide Rods
Top Cap Weight
Weight Cushions
Guide Rod Spacers
6
page 11