Route The Cable - Pacific Zuma Leg Press Option Assembly Instructions Manual

Zuma Leg Press Option Assembly Instructions
F . Route the cable through the pulleys on the Pulley
Plate. Have your assistant lift the Top Cap Weight to
release tension on the cable while you pull the cable
around the Support Arm pulley. Adjust the cable
retainers and make sure that the cable moves freely
before tightening any bolts.
Note: The pulleys should be positioned with the
edges in-line so that the cable moves freely. If a
pulley is not aligned properly, you can adjust its
position by using washers as spacers. Be sure that
you always maintain a minimum 1/8-inch clearance
between the bolt head and nearby structures.
G. Wrench tighten all pulley fasteners. (Steps 4C
through 5D.)
Step 5. Route the Cable, Continued
Support Arm
Pulley
plate
Route the cable as shown
E
around the pulleys and inside
the cable retainers before
tightening the fasteners.
1 2
4½" pulley
Support Arm
F
3 4
Main Upright
5 6
page 12