Advertisement
To begin programming, check the back of the RKE
transmitter to verify that the correct driver is selected.
Press the INFORMATION (INFO) and RESET (INFO
RESET) buttons at
the same time for about two seconds.
As mentioned, memory recall is the fourth feature to
appear. To "skip" past the first three personalization
features, press the INFORMATION (INFO) button.
When REMOTE RECALL MEMORY appears, the
driver is able to recall memory settings when the unlock
button on the RKE transmitter is pressed with the
ignition in LOCK. Press the TRIP SET (TRIP RESET)
button to select or press the
RESET
(INFO RESET)
button to answer no and to continue on to the next
prompt. (FEATURE ON displays when a yes response
is made and FEATURE OFF shows when a no response
is made.)
If a no response was made, the KEY IN RECALL
MEMORY prompt will show next. This choice recalls
memory settings when the key is placed in your
vehicle's ignition. A yes or no response is required.
For a list of the other personalization features available,
see "Memory and Personalization Features" later in
this section.
Each RKE transmitter is coded to prevent another
transmitter from unlocking your vehicle. If a transmitter
is lost or stolen, a replacement can be purchased through
your dealer. Once your dealer has coded the new
transmitter, the lost transmitter will not unlock your
vehicle. Each vehicle can have only two transmitters
matched to it.
Under normal use, the battery in your RKE transmitter
should Bast about four years.
You can tell
the battery is weak if the transmitter won't
work at the normal range in any location. If you have to
get close to your vehicle before the transmitter works,
it's probably time to change the battery.
When replacing the battery, use care not to touch
any of the circuitry. Static from your
body
transferred
to these
surfaces may damage
Advertisement
