Advertisement
SOURCE:
Press this button to switch from radio to
cassette tape play. If no cassette tape is in the tape
player, CASS appears on the display and then the radio
station appears briefly. The display then reverts back to
showing the time of day. Press this button again or
BAND to switch back to the radio.
6 EJECT: Press the upward triangle button to
remove a tape. The radio will play. Eject may be
activated with the radio off. Cassette tapes may be
loaded with the radio off but they will not start playing
until the PWR button is pressed. Press PWR or turn the
ignition key off to stop the cassette tape player. The tape
will stay in the player and resume play at the point
where it stopped. If you leave a cassette tape in the
player while listening to the radio, it may become warm.
CLN:
If this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See "Care of
Your Cassette Tape Player" in the Index. After
YOU
clean
the player, press and
hold
EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
Dolby@ Noise Reduction is manufactured under
a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
e
For information on the compact disc player, see "Trunk
Mounted CD Changer" later in this section.
Playing the Radio
OL:
Press this knob lightly to release it from its
stored position. The system will turn on. Press the knob
again to turn the system ~ f f . To increase volume, turn the
knob clockwise. Turn
it
counterclockwise to decrease
volume. The volume level will appear on the display.
Advertisement
