Advertisement
If you have not previously programmed the
hand-held transmitter to the universal transmitter, see
"Programming the Transmitter" earlier in this section. If
you have completed this programming already, you now
need to train the garage door opener receiver to
recognize the universal transmitter.
1. Remove the cover panel from the garage door opener
receiver (the receiver should be located by the
garage door opener motor).
receiver. The exact location
and
color of the button
may vary by garage door opener brand. If you have
difficulty locating the training button, refer
to
your
garage door opener manual.
2. Locate the training button on the garage door opener
3. Press the training button on the garage door opener
receiver for one or two seconds.
4. Return to the universal transmitter
in your
vehicle
and press the universal transmitter button you have
already programmed for two to three seconds. Press
the button again to make sure that the universal
transmitter has been trained to the garage door
opener receiver.
The garage door opener should now recognize the
universal transmitter. You may either use the universal
transmitter or the hand-held transmitter to open the
garage door.
If after following these instructions you still have
problems training the garage door opener, consult your
Cadillac dealer.
To erase all three programmed channels, hold down the
two outside buttons until the red light begins to flash.
Individual channels cannot
be
erased,
but can be
reprogrammed using the procedure for programming the
transmitter explained earlier.
Advertisement
