Advertisement
Be sure to keep the original hand-held transmitter
in case you need to erase and reprogram the
universal transmitter.
Note
to
Canadian Owners:
During programming, the
hand-held transmitter may stop transmitting after one or
two seconds. If you are programming from one of these
transmitters, you should press and re-press the button
on the hand-held transmitter every two seconds without
ever releasing the button on the universal transmitter.
Release both buttons when the red light on the universal
transmitter begins to flash rapidly.
Press and hold the appropriate button on the universal
transmitter. The red light
comes on
while the signal is
being transmitted.
Note that the universal transmitter is disabled when the
VALET button inside the glove box is activated. For
more information, see "Security Override" earlier in
this section.
Also note that if the hand-held transmitter appears to
program the universal transmitter but does not open
your garage door,
and
if the garage door opener was
manufactured after 1995, the garage door opener may
have a "rolling code" system. A rolling code system
changes the code of the garage door opener every time
you open or close the garage door.
To determine if you have this system, press the button
on the universal transmitter that you have programmed
already. If the red light on the universal transmitter
flashes rapidly for one or two
seconds
and
then
stops flashing, the garage door opener has a rolling
code system.
Advertisement
