Advertisement
When
REMOTE FLASH LIGHTS
appears on the
DIC
display, press the yes button to program the parking
lamps to blink once when the lock button on the RKE
transmitter is pressed and to blink twice when the
unlock button is pressed. If you don't want the parking
lamps to blink when using the
RKE
transmitter, press
the no button.
FEATURE ON will display if REMOTE FLASH
LIGHTS was selected and FEATURE OFF will show if
you answer no.
For a list of the other personalization features available,
see "Memory and Personalization Features" later in
this section.
This personalization feature enables the driver to
program the exterior lamps to turn on for 20 seconds
or to remain off when using the RKE transmitter
to
unlock your vehicle.
If exterior lighting is selected, the parking lamps,
taillamps, sidemarker lamps, license plate lamps,
low-beam headlamps, etc. will turn on for about
20 seconds or until the ignition key is turned to RUN.
Check the back of the RKE transmitter to verify that the
correct driver is selected before you start programming.
To
begin programming, press the INFORMATION
(INFO) and RESET (INFO RESET) buttons at the same
time for about two seconds. Exterior fighting
is
the third
feature to display. Press the WOWMATION (INFO)
button to "skip" past the first two features
--
DOOR
LOCKS
IN
GEAR
and
REMOTE FLASH LIGHTS.
When
EXT LIGHTS
AT UNLOCK appears, a "yes" or
"no" response is required. Press the TRIP SET (TRIP
RESET) button to answer yes or press the RESET
(INFO RESET) button to indicate a no response.
FEATURE ON displays when a yes response is made
and FEATURE OFF shows after a no response.
For a list of the other personalization features available,
see "Memory and Personalization Features" later in
this section.
Your vehicle may have memory personalization. If
it
does, REMOTE RECALL MEMORY will be the fourth
personalization feature to display on the DIC system.
Memory settings that have been previously programmed
(HVAC settings, radio preset settings, exterior lighting
choices, remote confirmation choices and programmable
automatic door 1oc.k choices) can be recalled by using
either the RICE transmitter or by placing the key in your
vehicle's ignition.
Advertisement
