Advertisement
Br:
Press the left m o w to reverse the tape rapidly.
Press it again to return to playing speed. The radio will
play while the tape reverses and REV will appear on the
display. You may use your station pushbuttons to tune to
another radio station while in REV mode.
FF:
Press the right arrow to fast forward to another part
of the tape. Press it again to return to playing speed. The
radio will play while the tape advances and FF will
appear on the display. You may ~ l s e your station
pushbuttons to tune to another radio station while in
mode.
SEEK-TUNE:
Press the right arrow to seek to the next
selection on the tape. Press the left arrow to search for
the previous selection on the tape (REP will appear on
the display). Your tape must have at least three seconds
of silence between each selection for SEEM-TUNE to
work. The sound will mute while seeking.
SCAN: Press this button. SCAN FF will appear on the
display until the next selection is found and then SCAN
PLAY will appear on the display. Use SCAN to listen to
selections for a few seconds. The tape will go to a
selection, stop for a few seconds, then go on to the next
selection. Press this button again to stop scanning.
SIDE: Press this button to change the side of
the tape
that is playing. (PLAY shows on the display.)
SOURCE: Press this button to switch from radio to
cassette tape play.
If no
cassette tape is
in
the tape
player, CASS appears on the display and then the radio
station appears briefly. The display then reverts back to
showing the time of day. Press this button again or
BAND
to switch back to the radio.
A EJECT:
Press the upward triangle button to remove
a tape. The radio will play. Eject may be activated with
the radio off if the ignition is on. Cassette tapes may be
loaded with the radio off but they will not start playing
until the PWR button is pressed. Press PWR or turn the
ignition key off to stop the cassette tape player. The tape
will stay in the player and resume play at the point where
it stopped. If you leave a cassette tape in the player while
listening to the radio, it may become w m .
CLN: If this message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See "Care of
Your Cassette Tape Player" in the Index. After you clean
the player, press and hold EJECT h r five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
Advertisement
