Advertisement
The lumbar control is
located on the outboard side
of each front seat. It
provides additional support
to your lower back and it
works independently of the
other seat controls. Use the
power seat control first to
get the proper position.
Then proceed with the
Bumbar adjustment.
Adjust the driver's seat
(including lumbar
adjustments) and both
outside mirrors to a
comfortable position and
then press the SET button.
Within five seconds,
To reshape the lower seatback, press the lumbar control
forward to increase support and rearward to decrease
support. Press the control up or down to raise or lower
the support mechanism.
Keep in mind that as p u r seating position changes, as it
may during long trips, so should the position of your
lumbar support. Adjust the seat as needed.
If you have the optional personalization package, the
power lumbar control can be programmed for memory
recall. F Q ~ more information, see "Memory Seat and
Mirrors" later in this section.
A second mirror and seating position may be
programmed by repeating the above steps and pressing
button "2,' instead of button 1. Note that each time a
memory button is pressed, a single beep will sound
through the left front speaker.
If your vehcle is in PARK (B), you
can
r e d l &or
and seatirag positions by briefly pressing button 1 or 2.
This will adjust the seat and mirrors to where you have
previously programmed them. If you have accidentally
pressed one of the memory recall buttons and want to stop
seat or mirror movement, press one of the manual seat or
mirror control buttons. T h ~ s cancels a memory recall.
Advertisement
