Installation - Kohler Mira Showers Escape Thermostatic 9.0 kW Installation And User Manual

Installation of Mira Escape
Warning! Turn off the electrical and water supplies before proceeding with the
installation of the Mira Escape. The electricity must be turned off at the mains
and the appropriate circuit fuse removed, if applicable.
Note! An installation template is supplied to help you install the Mira Escape.
Wall ¿xings are not supplied. For solid wall structures a red rawl plug and a
no. 8 x 1½" countersunk brass or stainless steel screw should be used. For
other wall structures such as panels alternative ¿xings may be required. A
minimum of 3 ¿xing screws should be used.
Remove the three cover retaining
screws, the cover and the service
tunnel.
Determine the direction of the inlet
water supply: top (falling), bottom
(rising), or back inlet .
Note! Make sure that the back inlet
does not go directly back into the wall.
Use a soldered elbow.
Swivel the inlet connector assembly
to suit. Remove the inlet blanking cap.
Avoid trapping the green earth bonding
wire.

INSTALLATION

Service Tunnel
10
Cover Retaining
Screw
Cover