Kohler LOURE 98452T-CP Installation Instructions Manual
Kohler LOURE 98452T-CP Installation Instructions Manual

Kohler LOURE 98452T-CP Installation Instructions Manual

Wallmount sensor faucet
Hide thumbs Also See for LOURE 98452T-CP:

Advertisement

Quick Links

安装说明书
98452T-CP
98453T-CP
安装之前
所有的资料是按最新出版的产品资料编写而成。
科勒公司保留任何时候不经通知即可改变产品特
性、包装或产品可供类型的权利。
说明书包括重要的安装、保养及清洁方面的内容,
请把这些资料交给用户阅读。
注意事项
1. 一定要先彻底冲洗供水管以清除管道中的杂
质,使用水源为自来水或可供饮用水。
2.请勿将强力及冲击施于产品,以免造成故障,
引起漏水。
3.安装、清洁龙头时,切勿损伤感应窗口表面,
以免造成故障。
4. 对于直流龙头, 安装时注意电池的正负极不
能装反,电池盒盖要拧紧,防止电池受潮。
5. 对于交流龙头,安装时务必按照说明书的要
求正确连接导线,龙头安装完毕后才可向电源盒
供电。
6. 一个交流电源盒最多可供两个感应龙头。
7. 交流电的总电源必须有合适熔断丝加以保护。
8. 请勿使产品感应窗口靠近强紫外线或电磁场。
9. 修理面盆时,用黑色电工胶布粘住感应窗口。
10.维修交流龙头时,必须断开交流电源并关闭
水源。
1205259-2-A
萝瑞入墙式单冷交流感应龙头(不带交流电源盒)
萝瑞入墙式单冷直流感应龙头
上海科勒电子科技有限公司
中国上海浦东新区金滇路18号E幢 邮编:201206
Wallmount Sensor Faucet
BEFORE YOU BEGIN
All information is based on the latest product information
available at the time of publication, Kohler Co. reserves
the right to make changes in product characteristics,
packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They
contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
Faucet is designed for tap water or potable water.
2. Do not apply excessive force to the product as doing so
may cause damage.
3. Do not damage the surface of sensing window when
installing or cleaning the faucet.
4. When installing DC type faucets, pay special attention
to the directions of battery electrodes. Tighten the battery
cover to prevent its exposure to moisture.
5. When installing AC type faucets, strictly follow indicated
instructions to perform electric connection. Do not turn on
AC power supply before installation is completed.
6. One AC power supply can power no more than two
faucets at a time.
7. General power supply must be protected by proper fuse.
8. Do not put the faucet near strong ultraviolet or
electromagnetic field.
9. Cover the sensing window with black tape when
repairing lavatory.
10.Turn off AC power supply and water supply before repairing
faucet.
萝瑞
LOURE
1

Advertisement

Table of Contents
loading

Summary of Contents for Kohler LOURE 98452T-CP

  • Page 1 安装之前 BEFORE YOU BEGIN 所有的资料是按最新出版的产品资料编写而成。 All information is based on the latest product information available at the time of publication, Kohler Co. reserves 科勒公司保留任何时候不经通知即可改变产品特 the right to make changes in product characteristics, 性、包装或产品可供类型的权利。 packaging, or availability at any time without notice.
  • Page 2 OPERATION INSTRUCTIONS 使用说明 Once user's hands enter the sensing range, the 手伸到出水口下方感应范围内 faucet automatically activates water flow. Water (感应距离随面盆、周围的情况 flows until 0.5~1 seconds after the hands are 而自动调节),水龙头出水。手 removed or until the faucet reaches its 1-minute timeout setting. The faucet adjusts its sensing 离开后0.5~1秒,水龙头自动止...
  • Page 3 安装尺寸 ROUGH-IN 98452T-CP 萝瑞入墙式单冷交流感应龙头 90~115 完整墙面 交流电源盒 台盆顶面 Max 10cm 用户自备 32 穿线管 用户自备角阀 G1/2外螺纹 Output: DC3V Input:AC220V 输出: 输入: 直流电压3V 交流电压220V 98453T-CP 萝瑞入墙式单冷直流感应龙头 排水组件 90~115 完整墙面 台盆顶面 41.2 Max 10cm 用户自备 32 穿线管 66.5 用户自备角阀 G1/2外螺纹 31.75 注意:台盆里侧边缘与产品安装墙面的 NOTE: To ensure beauty and comfort, the distance 距离不超过10cm,否则可能影响美观...
  • Page 4: Installation

    INSTALLATION 1. Install Mounting Bracket Assy. 一 安装暗装架组件 Determine installation method per 根据台盆大小确定安装方式,确保 lavatory size, and make sure the center 龙头出水中心正对台盆中心位置。 of faucet outlet aligns with the center of the lavatory. 1. Chisel out a Slot 1. 凿挖安装槽坑 Determine the installation lacation per 根据安装尺寸图确定安装位置,凿...
  • Page 5 用灰浆填埋槽道,在瓷砖上打好孔 Fill slurry into the slot and drill holes on tiles as shown in the figure. 张贴瓷砖后的墙面如图。 2. Install Faucet 二 安装龙头 1. 拧下自攻螺钉(1),拔出灰浆 1. Remove the self-tapping screws (1) and slide the slurry mold (2) off the 模套(2)。 body. 2.
  • Page 6 控制阀组件的安装固定 4. Fix the control box Remove the cover (6) after loose the 用螺丝刀拧下阀盒盖螺钉(7),将 screws (7). Determine the installation 阀盒盖(6)打开。根据安装尺寸图 location of control box (5) per rough-in, 确定控制阀组件(5)安装位置,打 then drill holes and place sheath in it. Make the control box cling on the wall 孔,打入膨胀管,使阀盒紧贴墙...
  • Page 7 最后,将电磁阀上的红绿线与对应阀 Finally, connect the red-green lines in solenoid valve and cover of valve box, 盒盖组件上的红绿线接插,将电池盒 then connect the black-orange lines in 或交流电源盒上黑橙线与主控板组 power supply and control board ( If you 件上黑橙线接插,(交流版请将主 faucet is AC version, please let the black-green line in the control board 控板组件上的黑橙线从小U型缺口...
  • Page 8 如何安装交流电源盒 HOW TO INSTALL THE AC/DC (若用户另购交流电源盒, TRANSFORMER (ONLY USED 具体安装详见其说明书) WITH TOUCHLESS FAUCET, AC) 一个交流电源盒供一个感应龙头 感应龙头 Wire connection pattern for one to one Faucet 交流电源盒 AC/DC transformer 用户自备角阀 接220V交流电 G1/2外螺纹 Connect AC 220V Please user prepare external thread check valve G1/2 穿线管...
  • Page 9 1. Install AC power unit (sticker on the back) dry, and avoid 1.电源盒 (背面有不干胶)应安装在干燥,不会被水 showering, soaking from water. Customer prepare wire 淋湿、浸泡的位置。根据需要客户自备穿线管及 tube and wire according to requirement. Wire tube 连接线。穿线管安装在墙内。建议交流电源线采用 should be put into the wall. Suggested wire: AC connection 带绝缘和护套层的电线,导体标称截面积...
  • Page 10 如何转换成混水感应龙头 HOW TO CHANGE TO MIXING SENSOR (若用户另购三通软管组件 FAUCE (If users buy the tee hose assy 1240574-SP) 1240574-SP) 用户自备角阀 用户自备角阀G1/2外螺纹 G1/2外螺纹 Please user prepare Please user prepare external thread check external thread check valve G1/2 valve G1/2 三通软管组件 Tee hose assy HOW TO CHANGE TO THERMOSTATIC 如何转换成恒温阀感应龙头...
  • Page 11: Installation Checkout

    许多清洁剂,比如氨水,去污粉及洁厕灵等,会 ammonia, chlorine, toilet cleaner etc. which could adversely 对电镀表面造成伤害,切忌使用。 affect the finish and are not recommended for cleaning. 有腐蚀性的清洁剂或溶剂不可使用于科勒的水龙 Do not use abrasive cleaners or solvents on Kohler faucets and fittings. 头及其配件上。 用户须知 IMPORTANT CONSUMER INFORMATION 1. Note of the Indicator Flashing 1.
  • Page 12 3.自动止水智能控制 3. Intelligent Stopping Flowing Water will flow out when object are putted into the sensing 物体进入感应范围内被感知,龙头自动出水。若 range. If the objects hold still for 15 seconds, the faucet will 15秒钟静止不动,水龙头自动止水。自动止水后, shut off automatically. After that, objects must be removed 手或物体离开感应范围后,再次进入感应范围内, from the sensing range.
  • Page 13: Troubleshooting

    Please contact with distributor or Kohler China Investment Co., Ltd., if the trouble remains after above-mentioned actions are taken. Please do not disassembly the other parts of the faucet freely except installing and replacing batteries.
  • Page 14: Service Parts

    萝瑞 LOURE SERVICE PARTS 零 件 图 Wallmount Sensor Faucet 1035611-SP-CP Drain 排水器组件 2.5mm Hex Wrench 2.5mm内六角扳手 1.5mm Hex Wrench 1.5mm内六角扳手 16306T-NA AC/DC Transformer (Only for 98452T- CP)交流电源盒 (仅用于98452T-CP) 1140049-SP Braided Hose 进水管 Key, Filter 滤网钥匙 1068120-SP Connection Wire Kit 接头线组件...

This manual is also suitable for:

Loure 98453t-cp

Table of Contents