Emerson PACSystems RSTi-EP Quick Start Manual page 27

Figure 15: Supercapacitor Carrier
6. Using the reverse procedure, install the new supercapacitor card onto its carrier
board. Check that the mounting holes are aligned properly before tightening
both the M2.5 screws. Recommended torque is 3 in-lb (0.3 Nm).
7. Reconnect the mating connectors.
8. Verify the assembly has been restored as shown.
9. Clean or blow away any contaminants that may have fallen into the enclosure.
10. Mount the side panel cover and tighten the four M3 Screws. Recommended
torque = 5 in-lbs (0.6 Nm).
11. The unit is now ready for use.
12. Mount the unit and reconnect power.
13. After power-up, confirm that the repaired unit does not log a Failed battery
signal fault in the controller fault table.
24 PACSystems™ RSTi-EP EPSCPE115 Standalone CPU Quick Start Guide
Board
Figure 16: Supercapacitor Board
Assembly
GFK-3039C