Configuration Pom; Connection To The Digital System; Reading And Writing Cvs With Pom - Esu SwitchPilot 3 Instruction Manual

Configuration POM

8. Configuration POM (Programming on the Main)
The SwitchPilot 3 Servo may remain installed on your layout during
programming. For POM to work, your command station must also
support „Programming on the Main (POM)" for accessory deco-
ders (!). Thanks to RailCom®, ECoS owners can even read out the
values (see chapter 11)..

8.1. Connection to the digital system

The SwitchPilot 3 Servo does not require any special connections. It
may remain wired as shown in chapter 5.2. respectively 5.3.

8.2. Reading and writing CVs with POM

Select "POM" as well as „Accessory decoder" on your command
station. Make sure that the correct accessory address is selected.
ADDRESS
Switch 1-4: 0001-0004
Switch 5-8: 0005-0008
Figure 12: Programming on the Main with ECoS
22
You can write all the CVs of the SwitchPilot 3 Servo decoder and
read them subject to the capabilities of the command station.
With the ECoS, this is done as follows:
• Go to the main programming menu of the ECoS.
• Select "POM", "DCC" and "Accessory decoder".
• Select the „POM address" of the SwitchPilot 3. Alternately the
corresponding turnout numbers are displayed as well.
• Select the CV you want to read or write.
• Press the „Read" or „Write" button.
Figure 13: Z21 Maintenance-Tool
With the aid of Z21 maintenance tool, the ROCO® Z21 can also
read or write the CV values of the SwitchPilot 3 Servo.
For this to work, RailCom® must be active on the SwitchPilot 3.
Please also refer to chapter 11.
Unfortunately, many command stations do not support the POM
mode for accessory decoders, but only for mobile (locomotive)
decoders. In this case, configure the SwitchPilot directly using its
display.