Table of Contents
Advertisement
Reassembly
Changing the seals of the
upper and lower flanges of
the piston
Rexson-Dispense-pneumatic-motor-3000-instructions-manual-sames-kremlin-582140110-EN.docx
The assembly is carried out in the reverse order of the disassembl y
sequence. Caution to the following instructions :
During the changing of the sensors (29), push them in
the opposite direction of the piston rod, then tighten
the screws,
The wheels must flush up the reversing rod,
Cable once again the parts according to the
pneumatic diagram,
Orientate the distributor base seal (7) according to the
A and B indexes.
Unscrew the ring (1) and remove the washer (2),
Remove the cover (3),
Unscrew the screw (52), put aside the cam (19),
Unscrew the 4 screws (20), take off the cover assembl y
(8),
Take off the reversing rod assembly (25) / piston (24) /
piston rod (32),
Take off the piston seal (11) and the bearing seals (15,
21 & 22),
Clean the parts, change them if necessary.
Disassembly / Reassembly Operation
22/07/2021
41
Advertisement
Table of Contents
