Environment - SAMES KREMLIN 3000 User Manual

3 Environment

Rexson-Dispense-pneumatic-motor-3000-instructions-manual-sames-kremlin-582140110-EN.docx
The equipment must be installed on a horizontal, stable and flat ground
(eg concrete slab).
Non-mobile equipment must be secured by suitable fixing devices (spit,
screws, bolts, etc.) to ensure its stability during use.
To avoid risks due to static electricity, the equipment and its
components must be grounded.
For pumping equipment (pumps, elevators, chassis, etc.),

a 2.5 mm section wire is attached to the equipment. Use
this wire to connect the equipment to the general
"earth". In severe environments (mechanical protection
of the ground wire, vibrations, moving equipment, etc.)
where damage to the grounding function is likely, the
user will have to replace the wire of 2, 5 mm supplied, by
a device more adapted to its environment (wire of
greater section, braid of mass, fixing by lug with eyelet
... ).
Have the earth continuity checked by a qualified

electrician. If earth continuity is not assured, check
terminal, wire and grounding point. Never operate the
equipment without solving this problem.
The gun must be "grounded" through the air hose or fluid

hose. In the case of spraying with a pistol equipped with
a bucket, the air hose must be conductive.
The materials to be painted must also be "grounded" by

means of clamps with cables or, if they are suspended,
by means of hooks which must remain permanentl y
clean.
Note: all objects in the work area must also be grounded.
22/07/2021
Env ironment
17