Table of Contents
Advertisement
Handling
Connection to compressed
air supply
30
manual-sames-kremlin-582140110-EN.docx
Set the pressure at the air regulator.
For proper operation and long life of the engine, the supply air must be
filtered and not lubricated (see § Maintenance).
It is imperative to install a decompression valve after the
air regulator and as close as possible to the engine inlet
in order to follow the decompression procedure (See the
pump manual § Operating problems).
The engine air supply hose must have an inside diameter
of at least 19 mm.
The engines are tested before shipping. Nevertheless,
before coupling the motor to a pump, it is necessary to
operate it under vacuum at a pressure of 1 bar / 14.5 psi
maximum for a few minutes.
Proceed as follows:
Couple the motor with the recommended pump.
Connect the main air supply to the motor.
Adjust the pressure at the air regulator.
22/07/2021
Rexson-Dispense-pneumatic-motor-3000-instructions-
Advertisement
Table of Contents
