Table of Contents
Advertisement
9.3 Description of options
9.3.1
Rinse hold
During the cycle the intermediate rinses and spins are performed.
-
Stops the appliance with water in the tub before the final spin cycle.
-
To drain the water, simply press the START / PAUSE button to perform the drain phase and the spin cycle.
-
9.3.2
Pre-wash
Adds a pre-wash phase at the start of the cycle with water heating to 30°C (or cold, if selected).
-
In COTTON and SYNTHETICS cycles, performs a short spin before passing on to the washing phase.
-
This option cannot be selected for WOOL and HAND WASH cycles.
-
9.3.3
Pre-wash
Adds a pre-wash phase with heating to 30°C (or cold, if selected) plus 30' hold with HAND WASH movement.
-
Completes the cycle.
-
9.3.4
Stains
Adds a 5-minute motor movement phase after heating to 40°C.
-
Water flow to the pre-wash / stains compartment to introduce the special stain-removal product.
-
This option cannot be selected for WOOL and HAND WASH cycles.
-
9.3.5
Super rinse
Adds two rinses to the COTTON cycle, one to the SYNTHETIC FABRICS – DELICATES cycles.
-
Eliminates the spin at the end of washing.
-
9.3.6
No spin
It eliminates all the spin phases.
-
It adds three rinses to the COTTON CYCLE and one to the SYNTHETIC FABRICS cycle.
-
9.3.7
Daily
Modifies the structure of the COTTONS – SYNTHETICS – DELICATES cycles to obtain good washing
-
performance in a short space of time.
9.3.8
Super quick
Modifies the structure of the wash phase of the COTTONS – SYNTHETICS – DELICATES cycles by half a load.
-
9.3.9
Delayed start time
Adds a pause before the start of the programme. The delay time is displayed on the three digits.
-
See page 12 series 7, page 20 series 8, page 28 series 9.
-
To start the cycle immediately after the countdown to the delayed start has already begun:
-
Press the START / PAUSE button, cancel the delay time by pressing the relevant button, then press START /
-
PAUSE again.
Technical Support - A.D.L.
39/83
599 74 12-51 Rev.00
Advertisement
Table of Contents
