Accessing Diagnostics; Quitting The Diagnostics System - Electrolux 6 Series Service Manual

Hide thumbs Also See for 6 Series:

Table of Contents

7 DIAGNOSTIC SYSTEM

7.1 Accessing diagnostics

Do not start the procedure with the buttons in the combination pressed

Series 6

Series 7

Turn the appliance on at the ON /

OFF switch.

In series 7, the first LED in the

right-hand row lights up.

Only in series 6 models, turn the

selector to the first position on the

right.

Press the START / PAUSE button

and the nearest option button

simultaneously (as shown in the

figure).

Hold the buttons / sensors down /

pressed until the LEDs and

symbols begin to flash in sequence

(approximately 3 seconds).

In the first position, the operation of the buttons, of the related LEDs and of the groups of symbols shown on the

LCD screen is checked; turn the programme selector dial clockwise to run the diagnostic cycle for the

operation of the various components and to read any alarms (see diagnostic test).

During this phase, if any key combination is pressed (except for the one relating to diagnostics), all the

combinations of options stored are deleted (Extra rinse, No buzzer, etc..) whereas for SERIES 9, the memories

with the customised programmes are also deleted.

To exit the diagnostic cycle, switch the appliance off, then back on and then off again.

Technical Support - A.D.L.

22/83

599 74 12-51 Rev.00

Table of Contents

7 series