Electrolux 6 Series Service Manual page 25

Position 6
No command
Position 7
Heating
Position 8
Leaks from the tub
Technical Support - A.D.L.
Purpose of the test:
Components activated:
Working conditions:
LCD display
Purpose of the test:
Components activated:
Working conditions:
LCD display
Purpose of the test:
Components activated:
Working conditions:
LCD display
To check the correct operation of the heater unit.
• door fastening device.
• Wash solenoid, if the water in the tub is not
enough to cover the heating element.
• Heating element.
• Door closed
• Water level high enough to cover the heating
element.
• Maximum time 10 mins or up to 90°C. (*)
Temperature in °C measured using the
NTC probe
To check for any water leaks from the tub during
operation.
• Door fastening device.
• Wash solenoid, if the water in the tub is not
enough to cover the heating element.
• Motor (anticlockwise rpm, pulse at 250 rpm)
• Door closed.
• Water level above.
• The heating element
Drum speed in rpm/10
25/83
-------------
-------------
-------------
599 74 12-51 Rev.00