Electrolux 6 Series Service Manual page 79

13.25.2 Drain pump
The drain pipe is held in place by two runners and 2 clips
that prevent it from withdrawing.
If the washing machine doesn't have a circulation system
the drain pump will be directly inserted into the filter unit.
• Disconnect the pump connectors.
• Open the clamp that holds the pipe onto the pump
outlet and remove it.
• Use a screwdriver to lower the clips that hold the
pump.
• Move the pump towards the back of the machine and
remove it.
If the washing machine has a circulation system the drain
pump will be inserted in a specific duct where the
circulation pump is also inserted.
• Disconnect the pump connectors.
• Open the clamp that holds the pipe onto the pump
outlet and remove it.
• Use a screwdriver to lower the clips that hold the
pump.
• Move the pump towards the back of the machine and
remove it.
13.25.3 Circulation pump
The circulation pump is inserted in a specific duct where
the drain pump is also fastened and it held in place by
two runners and 2 clips that prevent it from withdrawing.
• Disconnect the pump connectors.
• Open the clamp that holds the pipe onto the pump
outlet and remove it.
• Remove the drain pump, there is no need to
disconnect it electrically nor remove the pipe
connected to the outlet.
• Use a screwdriver to lower the clips that hold the
pump.
• Move the pump with the whole duct towards the back
of the machine and remove it.
Technical Support - A.D.L. 79/83 599 74 12-51 Rev.00