Table of Contents
Advertisement
13.2
Control circuit
After opening the control panel, we can remove the
control circuit board.
• Disconnect the connectors that link the control circuit
board to the main board.
• Unscrew the screws holding on the control panel
board.
• You do not need to remove the screws marked with
that hold the cover on the board.
13.3 Key spring and light diffuser
Once the board has been removed we can reach the key spring and led light diffusers.
• Remove the key spring and led light diffuser releasing them from the clips that lock them on.
13.4 Programme selector knob
Before refitting the board we recommend you remove the
knob to make it easier to insert the pivot.
• With the aid of a screwdriver press the three locking
clips on the know cover inwards.
• Simultaneously pull the knob cover until it is
completely removed.
Technical Support - A.D.L.
62/83
599 74 12-51 Rev.00
Advertisement
Table of Contents
