Table of Contents
Advertisement
4.
Hold the unit with the attached brackets against the underside of the table or other
furniture. On the mounting surface, mark the location of the screw holes in the bracket.
5.
Drill 3/32 inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep, into the mounting
surface at the marked screw locations.
6.
Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4 inch of the screw head protrudes.
7.
Align the mounting screws with the slots in the brackets and place the unit against the
surface, with the screws through the bracket slots.
Figure 21.
Mounting the SW USB under Furniture
8.
Slide the unit slightly forward or back, then tighten all four screws to secure it in place.
SW USB Series • Reference Information
33
33
33
Advertisement
Table of Contents
Need help?
Do you have a question about the SW USB Series and is the answer not in the manual?
Questions and answers