Sullair ES--6 Series Operator's Manual And Parts List page 22

Section 6
MAINTENANCE
6.6 PARTS REPLACEMENT AND ADJUSTMENT
PROCEDURES
Before doing compressor maintenance, discon-
nect compressor from power source and lock out
power source. Isolate compressor from line pres-
sure by closing recommended discharge shut- -
off valve and releasing all internal pressure from
compressor.
FLUID FILTER REPLACEMENT
Ref er t o F igur e 6 --
1. To prevent spillage and loss of reusable fluid,
place a contaminate--free fluid receptacle be-
neath fluid drain valve and fluid filter.
2. Drain fluid by removing fluid drain valve cap at tee
located beneath compressor (for complete fluid
change, drain fluid from cooler).
3. Using a strap wrench, remove the old element
and gasket.
4. Clean gasket seating surface.
5. Apply a light film of fluid to the new gasket.
6. Hand tighten new element until gasket is seated.
7. Continue tightening element an additional 1/2 to
3/4 turn.
8. Replace fluid. DO NOT OVERFILL.
9. Restart compressor and check for leaks.
AIR FILTER MAINTENANCE
Ref er t o F igur e 6 --
maintenance should be performed every six months
or more frequent if conditions so require.
Before doing compressor maintenance, discon-
nect compressor from power source and lock out
power source. Isolate compressor from line pres-
sure by closing recommended discharge shut- -
off valve and releasing all internal pressure from
compressor.
AIR FILTER ELEMENT MAINTENANCE
1. When performing maintenance, care must be
taken that no dirt or foreign matter enters intake
housing.
COMPRESSOR LUBRICATION GUIDE AND MAINTENANCE SCHEDULE
AMBIENT
TEMPERATURE LUBRICATION
- -10 F to +90 F Sullube 32
(- -23 C to +32 C) Sullair LLL- -4- -32
SRF 1/4000
ATF as per Dextron II
Motor Oil MIL- -2104E,
SPEC API SF CC,
CD SAE 10W Class SE
* 8,000 Hours or once a year.
** 4,000 Hours or more frequently if conditions so require.
16
WARNING
!
1.
2. A ir f ilt er ( P / N 250025 -- 421)
WARNING
!
FLUID & FILTER CHANGE
PERIOD (HRS.)
Figure 6-1 Fluid Filter (P/N 250026-982)
TEMPERATURE
GAUGE
FLUID FILL
PLUG
*FLUID FILTER
ELEMENT
* Replacement Element Kit P/N 250028--032
2. Clean exterior of air filter cover.
3. Remove the air filter cover by loosening the wing-
nut securing the cover.
4. Remove element and base. Clean base and inte-
rior of cover using a damp cloth. DO NOT use
compressed air to clean cover and base.
5. At this time replace element.
6. Replace cover.
SEPARATOR CHANGE
PERIOD (HRS.)
8000 *
8000 *
4000
1000
600
FLUID DRAIN
CAP
AIR FILTER CHANGE
PERIOD (HRS.)
8000 *
8000 *
4000
1000
600
4000 **
4000 **
4000 **
4000 **
4000 **