System Assembly Overview - DTK PAM-0035S User Manual

Mainboard Installation
(2) Perform system CMOS setup, enter correct drive geometry
information. For 4 HDDs system, there is no need to setup the drive
geometry information for Drives E: and F:.
(3) Install the Device Driver
Please refer to the README file in Driver Diskette for detail
installation procedures to be used in various kind of operating system
(DOS, Windows 3.1, Windows NT, OS/2 2.XX,
Novel 3.1X/4.0X).
3.7

SYSTEM ASSEMBLY OVERVIEW

After installing and connecting the mainboard, assemble components in the
following order:
1. Power Supply: Place the power supply so that it fits the raised tongues
on the chassis floor. Insert and fasten the two screws on the back panel
of the chassis.
connector.
2. Disk Drives: Slide disk drives into the chassis. Connect a wide 34-
wire ribbon cable to each disk drive; this cable will attach to an adapter
card. The power supply has four cables, each with four wires. Connect
these cables to the disk drives.
3. Adapter Cards: Insert each adapter card -- Disk Controller cards,
Video card, Serial/Parallel Interface card, etc. -- into an expansion slot.
Refer to the installation and configuration instructions that comes with
the card. Connect the disk drives to the Floppy Disk and Hard Disk
Controller cards.
4. Keyboard: Connect the keyboard to its connector.
Connect the power supply to the power supply
29