Logging Duofern Transmitters On / Off - RADEMACHER DuoFern Universal 9470-1 Instruction Manual

i

9. Logging DuoFern transmitters on / off

For the DuoFern Universal Actuator 9470-1 to be operated with
a DuoFern transmitter, you must log each desired transmitter
onto the DuoFern Universal Actuator 9470-1. You can log on
a maximum of 20 DuoFern transmitters (e.g. DuoFern manual
transmitter standard).
1.
Switch the desired DuoFern transmitter to log-on/log-off mode
(please refer to the respective instruction manual).
2.
Press the "Connect (log-on) button" [
(log-off ) button" [
9470-1.
3.
The DuoFern Universal Actuator 9470-1 then transmits either a
log-on or log-off signal.
Log-on / log-off mode remains active for 120 seconds.
4.
If the log-on/log-off process is successful, the STATUS LED will
light up green constantly.
5.
Log on / log off from the next DuoFern transmitter. To do so,
repeat steps 1 to 3 or else terminate the log-on / log-off process.
Observe the STATUS LED
The status LED lights up red if the log-on / log-off process fails,
for example if:
◆ 20 DuoFern transmitters have already been logged on.
◆ An unsuitable device (e.g. other DuoFern Actuator) is
logged on.
◆ An attempt was made to log off from a DuoFern transmitter
that is not logged on.
28
] of the DuoFern Universal Actuator
] or the "Disconnect
EN