Table of Contents
Advertisement
4
click
4
The metal ring just under the connector will click into the two snap hooks. The cable is hold between the two snap
hooks positioned lower on the organizer.
5
First Xpres drop cable installed.
6
All Xpres drop cables installed.
5.3
Install LC-connectorized cable
The separate cable retention kit TC-1467-IP (Cable retention: Dual cable ) must be used to install the LC-connectorized
cable in the CC 100 patch application.
Note:
In case of a duplex LC-connectorized cable, refer to SC-connectorized cable installation.
1
1
Install a cable tie in one slot in the carrier at the bottom position and in one slot at the top position. Make sure the
heads are oriented correctly. Install the pre-connectorized cable on each level and fasten the cable ties but don't
tighten. The cable should move fluently up and then down.
Note:
If only one cable to be installed, select the bottom position.
2
Slide the carrier into the slots of the organizer. Push the locking lip in the first slot backwards then slide the carrier
downwards. The locking lip returns into original position and the carrier is correctly seated. A clicking sound is
observed
3
Remove dust caps of both connector and adapter of the selected port. Clean the connector and adapter per
5
2
page 8 / 13
© 2021 CommScope, Inc. All Rights Reserved
6
3
Advertisement
Table of Contents
