Table of Contents
Advertisement
4
Splice feeder to input connector
Prepare and install the feeder cable as explained in the CC 100 base instructions TC-1425-IP. Route the feeder fibers to
the rear tray. Note that the fibers can be routed directly to the rear splice tray or via the uncut fiber storage.
4.1
Splice feeder direct to input connector
1
1
The inputs of the connectors patched at the front are routed to the splice tray at the rear as shown in image above.
The 250μm fiber is already prepared.
Note:
The pigtails and 250μm fibers have a color code to distinguish between the different ports. Advise prevailing
color code to select correct fiber.
2
Splice the input of the connectors to the feeder fibers (entering directly on the rear tray) by making a fusion splice:
make fusion splice per standard practice, store the splice protector in the splice protector holder and store over
length in loops on the tray.
3
If the feeder fibers come from the uncut storage zone, one of the fibers should be routed through the channel in
the middle of the tray before storing over length in loops on the tray.
Important:
Make sure all fibers are properly positioned under the lips and avoid bulging of the fiber.
Note:
The fiber guidance pen (situated on top of the loop storage basket) can be used to position all the fibers
under the lips.
2
page 4 / 13
© 2021 CommScope, Inc. All Rights Reserved
3
2
x6
x6
Advertisement
Table of Contents
