Advertisement
5.
Once the update has completed you will be prompted to restart the device, this can be done
using Audinate Dante Controller in the D evice or N etwork Config tabs.
6.
The firmware installation can be verified by using Dante Controller Device View on the
Status Tab associated with the device. (Only the software version is shown in the
manufacturer device section for the NET I/O device).
Your Dante Firmware is now updated!
Network I/O SB V2.1 Installation Notes
Page 5
Advertisement
Need help?
Do you have a question about the Network I/O SB 8.8 and is the answer not in the manual?
Questions and answers