Advertisement
Firmware Installation
1.
Plug a CAT5e/Cat6 network cable from a switch in the Dante Primary Network to the PC
being used to perform the software installation.
2.
Launch D ante Firmware Update Manager application, once launched select the network
interface being used to connect to the Dante network and click n ext .
3.
Select the correct firmware file for your unit using the b rowse b utton in the dialogue box:
For the SB8.8 use S SL_Stagebox_8In_8Out-2-1-22397.dnt
For the SB i16 use S SL_Stagebox_16In-2-1-22397.dnt
Leave the O verride Device Matching option unchecked, then click n ext .
Network I/O SB V2.1 Installation Notes
Page 3
Advertisement
Need help?
Do you have a question about the Network I/O SB 8.8 and is the answer not in the manual?
Questions and answers