Tele System STEALTH TS6807 User Manual page 35

4 Troubleshooting Guide
SYMPTOM
The LED on the front panel does not
light up.
Lack of signal.
No sound and / or images.
The remote control does not work.
Adjustments made in the menu are not
stored.
The program information
displayed.
The timer does not start or do not work
properly.
The receiver does not respond to the
remote control buttons.
Table continued on next page ...
POSSIBLE CAUSE
The receiver is disconnected from the
mains.
The power supply is plugged in but will
not work anyway.
Antenna cable is not connected to the
receiver.
Damaged antenna system.
The tuned channel is not broadcasting
or is obsolete.
Audio volume down or mute.
The receiver is in standby.
TV switched off or placed on the wrong
channel.
Audio-video cable (SCART or HDMI) is
not connected to the TV or damaged.
The resolution of the HDMI receiver is
not compatible with that of the
connected screen.
You are trying to see an outdated
channel or coded incompatible.
The remote control is in the wrong
operating mode.
Batteries not inserted or discharged.
Batteries inserted with the wrong
polarity.
The remote control has fallen and some
component has been damaged.
Not confirmed
settings.
The program transmits information
is not
about the event.
The receiver time is not set correctly.
The station broadcasts time data and /
or incorrect data.
The receiver clock is not set correctly.
Momentary Receiver lock.
The tuned channel transmits data
inappropriate that block the receiver.
Problems with the remote control.
Check that the receiver is plugged into
the mains.
Make sure that the power supply is
functioning. CAUTION: Risk
electric shock!
Connect the antenna cable to the
receiver.
Verify the integrity of your system
(antenna,
distribution devices, etc.).
It is advisable to test the system by
qualified personnel.
Change channels and / or upgrade or
reinstall the channel list (par.3.2).
Increase the audio volume level of the
receiver and the TV.
Turn on the receiver.
Turn on the TV screen and / or place it on
the correct audio-video channel
Restore
connection.
Connect the receiver via SCART to the
TV, adjust the resolution (para.3.1.3),
And then reconnect the HDMI cable.
Change channels and / or upgrade or
reinstall the channel list (par. 3.2).
Press the STB key par obtain control of
the receiver.
Insert the batteries or replace them.
Insert the batteries in the correct
direction. Follow the instructions inside
the battery compartment.
Contact your dealer to purchase a new
remote control.
before changing After each change, press any specific
confirmation / save button.
Adjust the receiver time (par. 3.5)
Adjust the receiver time (par.3.5).
Disconnect the power of the receiver and
plug it back in after a while.
Disconnect the antenna cable, restart
the phone, change the channel, then
connect the antenna.
See relevant recommendations in this
table.
TS6807 STEALTH
REMEDY
coaxial cable, signal
the proper audio-video
13