Advertisement
3 INSTALL POWER CORD AND FLEXIBLE DOOR CORD SHIELD
1. Unroll the DSB power cord and feed the
non-connector end down through the wire
feed-thru channel, the drilled holes and
out the side of the base riser as shown.
2. Leave about a 6-inch loop from the hole in
the side of the base riser to the end of the
connector (to allow for connection to the
PC board later).
Groove in
Door Cord
Shield
5. Insert the door cord shield through the holes drilled in the part and up to the wire feed-thru
channel in the base riser.
6. Using needle-nose pliers, install the E-clip into a groove on the door cord shield between the
internal part ribs as shown.
Connector
Power Cord
E-clip
Base Riser
Flexible Door Cord Shield
3. Insert the door cord insert into the end of the
flexible door cord shield.
4. Slide the flexible door cord shield (door cord
insert first) over the power cord from the
non-connector end and up to the hole in the
side of the base riser as shown.
E-clip
Page 14
Door Cord
Insert
PN# 500-22700
Rev. F, 03/11
Advertisement
