Advertisement
7. Install the front wheel.
Clean both sides of the front brake discs with
a clean shop towel and Pro Honda Brake
Cleaner or equivalent.
Remove the caliper mounting bolts. Be
careful not to get dust and dirt on the ends of
the mounting bolts.
Note that a single 8 x 45 mm caliper bolt is
attached to the lower left fork leg.
Note that the shoulders on each wheel collar
are of different sizes. It is important to install
them with the correct sides facing the wheel.
Install the 16.5 mm left-side collar with the
10 mm deep shoulder side facing the wheel.
Install the 27 .5 mm right-side collar with the
34 mm outside diameter shoulder facing
the wheel.
Position the front wheel between the
fork legs.
Slide the axle shaft through the left fork leg,
the 16.5 mm left-side collar, front wheel,
27 .5 mm right-side collar, and right fork leg.
Push in on the axle shaft so the left end of the
axle shaft is flush with the surface of the left
fork leg.
Install and tighten the axle bolt to the
specified torque.
Torque: 58 ft-lbs (8.0 kg-m, 78 N·m)
Tighten the left, then the right axle pinch bolts
to the specified torque.
Torque: 16 ft-lbs (2.2 kg-m, 22 N·m)
On ST1300A, verify the clearance between the
ABS front pulser ring and sensor is as shown.
Reinstall the caliper bolts and tighten to the
specified torque.
Torque: 23 ft-lbs (3.2 kg-m, 31 N·m)
Clean both sides of the rear brake disc with a
clean shop towel and Pro Honda Brake
Cleaner or equivalent.
©2004 American Honda Motor Co., Inc. - All Rights Reserved
RIGHT SIDE
CALIPER
BOLTS
AXLE BOLT
27.5 mm
RIGHT SIDE
COLLAR
PINCH
BOLTS
CALIPER
LEFT SIDE
BOLT
8 x 45 mm
CALIPER
BOLT
AXLE
SHAFT
16.5 mm
LEFT SIDE
COLLAR
0.4 - 1.2 mm (0.02 - 0.05 in)
7
Advertisement
