Advertisement
2004 ST1300/A
5. Remove the motorcycle from the
crate base (cont.).
Remove the shipping braces, nuts, and
protective covering from the foot pegs on
both sides of the motorcycle.
Lift the motorcycle free from the crate base
and remove the base.
On a firm, level surface, lower the centerstand
and lower the motorcycle until it is resting on
its rear wheel and centerstand.
6. Install the front fender.
CAUTION
Be extremely careful when loosening
the pinch bolts and removing the axle
shaft. The motorcycle could lose
stability and fall, harming you and
damaging the motorcycle.
Loosen the two right axle pinch bolts.
Remove the axle bolt.
Loosen the two left axle pinch bolts.
Remove the axle protective covering and
axle shaft.
Position the reflector stays on the inside of
the front fender by aligning them with the
projections on the front fender. Install the
reflector stays with two 6 x 20 mm pan head
screws and rubber washers.
Secure the reflectors to the stays with two
6 mm nuts.
Torque the nuts.
Torque: 9 ft-lbs (1.2 kg-m, 12 N·m)
Position the front fender between the fork
legs and attach it to the fork stays with two
6 x 18 mm socket bolts. Secure the brake hose
stays with two 6 x 16 mm flange bolts.
Torque the bolts.
Torque: 9 ft-lbs (1.2 kg-m, 12 N·m)
6
PINCH BOLTS
AXLE
BOLT
PROTECTIVE
COVERING
(discard)
FORK STAY
UPPER
FORK STAY
LOWER
REFLECTOR
STAY
6 mm NUT
©2004 American Honda Motor Co., Inc. - All Rights Reserved
PROTECTIVE
COVERING
(discard)
SHIPPING
BRACE
AXLE SHAFT
6 x 16 mm
BOLT
6 x 18 mm
BOLT
RUBBER WASHER
6 x 20 mm
BOLT
REFLECTOR
Advertisement
