Advertisement
2004 ST1300/A
17. Service and install the battery (cont.)
Reinstall the front seat:
Insert the seat prong under the tank and align
the two recesses with the prongs at the rear
of the tank. Make sure that the seat
adjustment guides align with the holes in the
seat and push down on the rear of the seat to
secure it into position.
Reinstall the rear seat:
Reinstall the rear seat by following the
instructions in step 13 on page 11.
18. Check the coolant level.
Check the coolant level at the coolant reserve
tank. If the level is low, remove the coolant
reserve tank cap and add Pro Honda coolant
or an equivalent 50/50 mixture of antifreeze
and distilled water to restore the level to the
UPPER level mark. Do not spill coolant on
painted or plastic surfaces as it can damage
the finish.
19. Verify the throttle free play.
Operate the throttle to confirm that it moves
smoothly and returns automatically from any
open position to the fully closed position in all
steering positions.
Confirm the throttle grip free play:
Throttle free play: 1/16 - 1/4 in.
(2 - 6 mm)
Make adjustments at the throttle grip
adjuster by loosening the lock nut and
turning the adjuster. Tighten the lock nut
after adjustment.
16
FRONT SEAT
RECESSES
SEAT ADJUSTMENT
GUIDES
PRONGS
UPPER
RESERVE
LEVEL MARK
TANK
LOWER
LEVEL MARK
1/6 - 1/4 in. (2 - 6 mm)
©2004 American Honda Motor Co., Inc. - All Rights Reserved
HOLES
PRONG
RESERVE
TANK CAP
LOCK NUT
ADJUSTER
Advertisement
