Volvo A2DIY-VOL Quick Start Manual page 3

AUX input connection: Connect supplied 3.5mm audio cable (See Fig.
4.
5) to module "AUX" jack (See Fig. 6). Route and connect other end to
front of the dash or wherever Aux device will reside (within 3 ft.)
Fig. 5
Fig. 6
Connect push button (See Fig. 7) to module "CTL" jack
5.
Fig. 7
Control button
Secure push button in location that is within reach of the driver (cable
6.
is 6ft. long). Simply remove tape backing (See Fig. 7) and adhere to
surface.
Install microphone to visor or headliner using included visor clip (See
7.
Fig. 8).
Fig. 8
Microphone
Carefully route microphones 3.5mm plug down side pillar and behind
8.
the dash and connect to module "MIC" input.
Tap adapter harness RED wire to one of two Green/brown Accessory
9.
wires on radio harness (See Fig. 9)
Tap YELLOW wire from installation harness to yellow/purple (Battery
10.
supply) wire on radio harness or wherever 12V battery is available in
your car (See Fig. 9)
Fig. 8
Visor clip