Troubleshooting - pro.point 8843948 Instructions Manual

8843948
WARNING! Only qualified service personnel should repair the
tool. An improperly repaired tool may present a hazard to the
user and/or others.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants are
not suitable and will damage the tool or cause a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool.
Penetrating oil acts as a solvent that will dissolve the tool's
grease packing and may damage the o-rings, causing the tool to
seize or malfunction.
1. All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a
generous amount of air tool oil in the air inlet and then run the tool
under no load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool's coupler plug
before each use and after every hour of continuous use. The tool will
not work properly without lubrication and parts will wear prematurely.
3. Turn the tool on its side with the oil inlet (C) facing up. Remove the
screw. Fill the oil tank with air tool oil daily to lubricate the internal
mechanism. Reinsert the screw.
4. Avoid adding too much air tool oil as this can cause premature
power loss and eventual tool failure. A qualified technician will
need to take the tool apart and clean out the excess oil.
5. Apply a generous amount of air tool oil to the tool before storing it
for an extended period of time (overnight, weekend, etc.). Run the
tool for approximately 30 seconds to ensure the oil is evenly
distributed throughout the tool. Store it in a clean and dry location.

TROUBLESHOOTING

Visit a Princess Auto Ltd. location for a solution if the tool does not
function properly or parts are missing. If unable to do so, have a
qualified technician service the tool.
PROBLEM(S)
Tool runs at normal
speed, but loses
power under load.
10
2-3/4 x 17-1/2 in. Straight Line Air Sander
POSSIBLE CAUSE(S)
Motor parts worn.
SUGGESTED SOLUTION(S)
1. Have a qualified technician
service the tool.
2. Replace tool or parts.
For technical questions call 1-800-665-8685
V1.0