Table of Contents
Advertisement
Available languages
Available languages
8843948
never exceed the maximum pressure rating of the tool (see
Specifications). Exceeding the maximum PSI rating can create a
bursting hazard, causing injury and property damage.
5.
Never use oxygen, combustible gas or any other bottled gas as a
power source. Any power source other than an air compressor
could cause an explosion and serious personal injury.
6.
Turn OFF the valve and discharge any remaining air pressure after
each use or before adjusting the tool.
7.
Do not leave the air tool unattended with its compressed air supply
on. Turn off the compressed air supply and bleed the air tool of any
remaining compressed air before leaving the air tool unattended.
8.
Serious injury may occur from loose debris being propelled at high
speeds from the compressed air stream. Always wear OSHA
approved safety glasses to protect the eyes during operation of the air
compressor.
9.
Always turn off the air compressor and drain tank pressure
completely before attempting maintenance or attaching air tools.
Release pressure slowly from the system.
AIR HOSE PRECAUTIONS
1.
Inspect the tool's air hose for cracks, fraying or other faults before
each use. Discontinue use if the air hose is damaged or hissing is
heard from the air hose or couplers. Replace the defective air hose.
2.
Do not allow people, mobile equipment or vehicles to pass over
the unprotected air hose. Position the air hose away from high
traffic areas, in a reinforced conduit or place planks on both sides
of the air hose to create a protective trench.
3.
Prevent damage to the air hose by observing the following:
3.1 Never carry the tool by the air hose.
3.2 Keep the air hose behind the tool and out of the tool's work path.
3.3 Keep the air hose away from heat, oil, sharp edges or moving
parts.
4.4 Do not wrap the air hose around the tool as sharp edges may
pierce or crack the air hose. Gently coil the hose and either
hang on a hook or fasten with a device to keep hose together
when storing.
6
2-3/4 x 17-1/2 in. Straight Line Air Sander
For technical questions call 1-800-665-8685
V1.0
Advertisement
Table of Contents
