Pressure Drop; Care And Maintenance - pro.point 8843948 Instructions Manual

V1.0
To produce the best finish possible, start with a coarse grit sanding paper
and gradually change to finer and finer grit sandpapers. A final sanding
with a well-worn fine sandpaper will produce a professional looking finish
that in many cases will not need hand sanding.
1. Grip the sander with one hand on the handle (D) and the other
hand on the knob handle (B).
2. Squeeze the trigger (D) gently to start the tool. Then carefully apply
the tool onto the work surface.
3. Move the sander back and forth slowly in a wide area, overlapping
the work surface area as needed.
4. Lift the sander off of the work surface before stopping the motor.
5. When finished with the tool, turn off the air compressor, disconnect
the air hose and discharge any residual air remaining in the tool.
Put the tool away in a safe storage area.

PRESSURE DROP

Apply the air consumption and pressure rate numbers to the tool's air
inlet, not the compressor's outlet. Calculate the pressure drop for your
air supply set-up and increase the compressor outlet pressure to
compensate. Make sure you do not exceed the maximum pressure for
any part of your air supply system.
Installing a pressure gauge at the tool inlet is the best way to measure
the air pressure and adjust the compressor's output.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient,
easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment and hoses periodically. Have
damaged or worn components repaired or replaced by an authorized
technician. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool clean, dry and free from oil/grease at all times.
6. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
Visit www.princessauto.com for more information
2-3/4 x 17-1/2 in. Straight Line Air Sander 8843948
9