Bunn ITCB Operating & Service Manual page 37

PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
Setting Pulse Brew – MANUAL Pulse Brew
NOTE: If the brewer is already on the SET PULSE
BREW screen, skip steps 1 through 6, and proceed
directly to step 7.
1. Press and hold the right hidden button until the dis-
play reads SET LANGUAGE. Press the right hidden
button until the display reads REVIEW RECIPES.
2. Press YES to proceed. The display should now read
TEA 1, along with MODIFY SHOW NEXT.
3. Press and release NEXT to advance to the desired
coffee recipe to be modified.
4. Press and release MODIFY. The display should read
BREW OZ:
5. Press and release DONE. The display should read
2 BATCHES DONE?
6. Press and release YES. The display should now
read SET PULSE BREW.
7. Press and release YES. The display should now
read SELECT METHOD.
8. Press and release MANUAL. With MANUAL flash-
ing, press and release NEXT.
9. The display should now read 1
batch light will be blinking. Press and release the
batch size to be modified.
10. Using (-) and (+), adjust the 1
11. When finished, press the other batch size and repeat
step # 10.
12. When finished setting both batch sizes, press and
release DONE.
13. The display should now read OFF TIME. Adjust
the OFF TIME using (-) and (+).
14. When finished, press the other batch size and repeat
step # 13.
NOTE: To disable pulse brew, set 1
For recipes with a brew volume greater than 86.0 oz.
and pulse brew disabled, the following message will
appear after the BREW button is pressed, COFFEE
FUNNEL?...PRESS BREW "X".
15. When finished setting both batch sizes, press and
release DONE.
16. The display should now read LAST ON:. Adjust the
LAST ON TIME using (-) and (+). If PREINFUSION
is desired, set the LAST ON TIME to PreI.
17. When finished, press the other batch size and repeat
step # 16.
ON TIME and a
st
ON TIME.
ST
ON TIME to OFF.
ST
Page 37
18. When finished setting both batch sizes, press and
release DONE.
19. The display will show the three times just entered.
Press and release each batch size to display the set-
tings for that batch. If the 1
the display will read PULSE BREW DISABLED. After
a 5 second delay, the display will read 2 BATCHES
DONE?
20. If both the pulse brew settings for both batch sizes
are not correct, press and release NO to return to
the 1 ON TIME setup screen and repeat steps 10
ST
through 19.
21. If both batch sizes are correct, press YES. The
display should now read DRIP TIME. To exit to
the MAIN SCREEN, press and release the ON/OFF
button.
ON TIME is set to OFF,
ST
36748 070706