Set New Recipe - Bunn ITCB Operating & Service Manual

PROGRAMMING THE BREWER (cont.)
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE (to set a new COFFEE recipe using
a Smart Funnel or RECIPE CARD)
Using a Smart Funnel and a G9-2T DBC or MHG
Grinder:
This function allows the operator to set BREW VOL-
UMES, PULSE BREW TIMES AND DRIP OUT TIMES for
each coffee name preset in the grinder's memory.
MASTER TEMP XXX°
NO YES
CYCLES THROUGH
TWO SCREENS
(COFFEE NAME)
NO
BREW BREW
A
BEGIN SETUP OF
(COFFEE NAME)
SET UP BREW VOLUMES, BYPASS PERCENTAGE,
PULSE BREW TIMES, AND DRIP OUT TIME
2 BATCHES DONE?
NO
BREW
(COFFEE NAME)
SETUP COMPLETE

SET NEW RECIPE?

NO
BREW BREW
A B
INSERT FUNNEL
WITH NEW NAME
2 SEC.
QUIT SETUP?
YES
BREW BREW
A B
FUNNEL DETECTED
FUNNEL
CONTAINS NAME
YES
BREW
B C
YES
BREW BREW
A B C
Certain coffee names are stored in the grinder's memory.
When a particular name of coffee is ground into the
Smart Funnel, that name and the batch size selected
are transferred from the grinder to the programming
CHIP located in the funnel handle. The funnel is then
inserted into the brewer's funnel rails. The SENSING
COIL on the brewer reads the information contained
in the handle. The name of the coffee flavor will then
appear on the display. This allows the operator to set
the BREW VOLUME, PULSE BREW TIMES and DRIP
OUT TIME for that particular coffee name. It also allows
YES the operator to set other brewing parameters, such as
BREW TEMPERATURE, BREW LOCKOUT, etc. Each
BREW
coffee name can be set individually to provide optimum
C
brewing quality.
BREW
C
FUNNEL CONTAINS
NO NAME
MUST GRIND INTO
FUNNEL FIRST
SEE SEPARATE DIAGRAMS
FOR SETUP INSTRUCTIONS
P2854-1
Page 22
36748 101505