Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
15.5
Refilling coolant
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
–
Position the motorcycle upright.
–
Place an appropriate container under the water pump cover.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump
cover
F01548-11
–
Make sure that screw
–
Position the motorcycle upright.
–
Pour coolant in up to measurement
Guideline
A
Dimension
ator fins
Coolant
F01549-10
–
Mount the radiator cap.
–
Take a short test ride.
–
Check the coolant level. (
COOLING SYSTEM 15
1
2
. Take off radiator cap
1
with a new seal ring.
M6
10 Nm (7.4 lbf ft)
1
is tightened.
A
above the radiator fins.
10 mm (0.39 in)
over the radi-
1.20 l
Coolant (
(1.27 qt.)
p. 96)
.
p. 126)
97