IKA C 1.30 Operating Instructions Manual page 7

Ensure that only trained staff work with the appliance.
Follow the safety instructions, guidelines, occupational health and safety and
accident prevention regulations.
Page
Furthermore, toxic combustion residue in the form of gases, ashes or condensation,
for example, is possible in the inner wall of the washing bottle.
8
9
9
DANGER
9
17
When handling combustion samples, combustion residue and auxiliary materials,
18
please observe the relevant safety regulations. The following materials, for
example, could pose a risk:
-
-
-
-
-
bsolu-
. Non-
DANGER
injury.
ant for
le gas cleaning system or extraction system.
osition
easure-
DANGER
The venting speed may be infinitely adjusted via a throttle valve by using a
manual adjusting screw. Please note that the throttle valve is closed at the
beginning of the venting operation.
n full
safety
Do not operate without the ground clamp included in the delivery quantity!
The maximum permitted operating pressure is 40 bar (at the pressing tubing
where
(d)).
Please observe the general laboratory guidelines when handling glass vessels.
Observe the accident prevention requirements applicable to
the activity and the work station.
Wear your personal protective equipment.
corrosive
highly flammable
explosive
bacteriologically contaminated
toxic
Combustion gases are hazardous to health, there-
fore the venting hose must be connected to a suitab-
The C 1.30 venting station is used for controlled venting
of IKA C1 calorimeter.
Unpacking
• Unpacking
- Please unpack the device carefully
- In the case of any damage a report must be sent immediately
(post, rail or forwarder).
• Delivery quantity
a) Base plate
b) Gas washing bottle
c) GL screw joint
d) Pressure tubing
c
e) Drainage hose
g) Fork spanner
h) Set of O-Rings
i) Operating instructions
d
b
a
e
c
e
7