Programming The Brewer - Bunn ICB-TWIN Installation And Operating Manual

Infusion series with smart funnel

Hide thumbs Also See for ICB-TWIN:

Illustrated parts catalog (25 pages)

Programming manual (39 pages)

Installation & operating manual (24 pages)

Table of Contents

The programming of the brewer is divided into two levels. There is one function in Level 1. All other functions

are accessed in Level 2.

The following function screens are in order of appearance. Each screen will have instructions on how to

access and the procedures for programming the various functions of the brewer.

To exit the programming mode at any time, press and release either ON/OFF pad located on the front switch

panel. The display will return to the MAIN SCREEN.

If none of the five programming switches are pressed within one minute during the setup of the brewer,

the programming of the function screen that is being set will be exited and the display will return to the MAIN

SCREEN.

Always remember to place a container and funnel under the sprayhead when operating the brewer during

the set-up of CALIBRATE FLOW, and testing the brew and bypass valves in SERVICE TOOLS/TEST OUTPUTS.

MAIN SCREEN

READY TO BREW

WATER TEMP: 200°

This screen will be shown when the brewer is ready

for use. The screen displays the water temperature

in the tank. When the water in the tank reaches the

correct set temperature, the display will change from

HEATING to READY TO BREW.

PROGRAMMING LOCKOUT SWITCH (located on the

memory module board prior to S/N ICBT001330

- located on the main circuit board S/N ICBT001330

and after)

This switch can be set to prevent access to the

programming settings of the brewer. Once all the cor-

rect brew settings are programmed, the operator can

set the switch to the "ON" position to prohibit anyone

from changing the settings. With the switch in the

"ON" position, the programming menus can still be

accessed to view the current settings. However, no

changes will be saved.