Why Bunn Brews Better; Programming Your Brewer; Set Clock - Bunn PHASE BREW Use & Care Manual

BUNN Phase Brew is different from any brewer you've used before. Unlike ordinary coffee
makers, BUNN Phase Brew doesn't 'drip' right away. In fact, it doesn't drip at all. That's
because BUNN Heat & Release Technology heats all the water to the right temperature,
then quickly releases it through our unique sprayhead for an optimal 4-minute brewing
phase and amazing coffee flavor in just 10 minutes!
BUNN PHASE BREW

PROGRAMMING YOUR BREWER

:
You must set the clock to use the brewer and the optional Auto-Start function. Remember to
note
reset the clock for time changes and power outages.
Plug 3-prong power cord into standard
1.
electrical outlet.
Display will flash until clock is set.
2.
Press Clock button.
3.
Place BUNN coffee filter and coffee
1.
grounds into the Brew Funnel and slide
into the Funnel Guides.
Fill brewer with 20 – 40oz of water and
2.
place Carafe on base of brewer (failure to
follow steps 1 and 2 may result in property
damage).
Press Auto-Start button. Hour and Minute
3.
buttons will light up, time will flash on
digital display.
Set time using Hour and Minute buttons.
4.
Numbers scroll forward only. Stop at
desired Auto-Start time. Take care to
select correct AM/PM time.
When desired brewing time is on the
5.
digital display, it will be set and Auto-
Start will activate in 10 seconds. Once
activated, Auto-Start button will illuminate

WHY BUNN BREWS BETTER

PHASE BREW VS. TYPICAL DRIP
-
auto
VS.

set clock

Set time using Hour and Minute buttons.
4.
Numbers scroll forward only. Take care
to select correct AM/PM time.
Press Clock button again to lock in time.
5.
(
start optional
white. Do not press the Auto-Start
button again as it will cancel your selected
Auto-Start time.
To check your Auto-Start setting at any
6.
time, press the Auto-Start button and the
digital display will flash the programmed
time. The flashing time will remain the set
time unless you change it. After 10 seconds
with no buttons pushed, the Auto-Start
button will illuminate and Auto-Start is set.
The Auto-Start function must be
7.
activated each time you want to pre-
schedule a brew. If the Auto-Start button
is not illuminated, the Auto-Start
function is not activated.
To cancel a programmed Auto-Start, press
8.
the Auto-Start button twice.
3
TYPICAL DRIP
)