Table of Contents
Advertisement
LA-RAK
TOURING RACK
user manual
VERSION 2.0
23. Personnel health and safety
During installation of an assembly, personnel should wear protective headgear and footwear at all times.
Under no circumstances personnel should climb on the assembly.
WARNING
24. Additional rigging equipment
L-ACOUSTICS
®
ACOUSTICS
.
®
WARNING
It is the user's responsibility to ensure that the Working Load Limit (WLL) of all additional hardware rigging
accessories is greater than the total weight of the rack assembly in use.
25. Suspension points
It is the user's responsibility to ensure that the Working Load Limit (WLL) of the suspension points and/or
chain hoists is greater than the total weight of the assembly in use.
WARNING
26. System load capacity and setup safety limits
Load capacity and setup safety limits outlined in this manual must never be exceeded.
WARNING
27. Local regulations
Some countries require higher Ultimate Strength Safety Factors and specific rigging approvals. It is the user's
responsibility to ensure that any overhead suspension of L-ACOUSTICS
WARNING
accordance with all applicable local regulations.
As a general rule, L-ACOUSTICS
28. Flying an assembly
Always ensure that nobody is standing underneath an assembly when it is being raised.
As the assembly is being raised, check each individual rack to make sure that it is securely fastened to the
WARNING
component above. Never leave the system unattended during the installation process.
29. Ground stacking an assembly
Do not ground stack an assembly on uneven ground or platform.
If the assembly is ground stacked on a structure, platform, or stage, always check that this last can support
WARNING
the total weight of the system.
Secure the assembly to the structure, platform, or stage using ratchet straps or any other applicable device.
30. Dynamic load
When an assembly is deployed in an open air environment, wind effects should be taken into account. Wind
can produce dynamic stress to the rigging components and suspension points. If the wind force exceeds 6
bft (Beaufort scale) it is highly recommended to lower down and/or secure the assembly.
WARNING
31. Manual
Keep this manual in a safe place during the product lifetime.
This manual forms an integral part of the product.
WARNING
Reselling of the product is only possible if the user manual is available.
Any changes made to the product have to be written in this manual, particularly in the event of resale.
LARAK_UM_EN_2.0
is not responsible for any rigging equipment and accessory that is not manufactured by L-
®
recommends the use of safety steel at all times.
w w w . l - a c o u s t i c s . c o m
®
systems has been made in
4
Advertisement
Table of Contents
