Table of Contents
Advertisement
LA-RAK
TOURING RACK
user manual
VERSION 2.0
6.7
Digital audio cabling
6.7.1
Internal cabling
With digital audio, internal cabling uses a constant scheme. As digital audio requires an active refresh of the signal that is
provided by the LA-AES3 card, routing modularity is achieved through external cabling [6.7.2]. The only internal cabling
scheme that should be used is shown in Figure 24.
The XLR3 cables (IN/LINK) at the back of the LA-PANEL AES3 allow distributing up to six different digital audio signals.
Each IN connector of the front patch panel of the LA-PANEL AES3 is cabled to the AES/EBU IN connector on the
respective LA8, using the appropriate IN XLR cable..
Each AES/EBU LINK connector on the amplifiers is then cabled to the respective LINK connector of the LA-PANEL
AES3 using the appropriate LINK XLR cable.
Figure 24: Internal digital audio cabling (LA-POWER not represented)
Figure 25: Digital audio connection panels on LA-PANEL and LA8 (rear views)
LARAK_UM_EN_2.0
LA-PANEL AES3 rear connection panel
w w w . l - a c o u s t i c s . c o m
LA8 digital connection panel
30
Advertisement
Table of Contents
