Network Cables Replacement Procedure; Spare Parts And Recommended Tools - L-Acoustics LA-RAK User Manual

7.3

Network cables replacement procedure

When leaving the factory the LA-PANEL features four CAT5e U/FTP cables. If cables replacement is needed follow the
procedure below:
a. Remove the LA-PANEL from the LA-RAK by removing the four front Pozidriv
b. Unscrew the back protecting plate by removing the four Torx
c. Remove the old cables and install new ones.
Check that the connector bodies of the new cables are short enough to allow putting the plate back in
place.
CAUTION
d. Put the plate and Torx
e. Put the LA-PANEL and Pozidriv
Figure 35: Replacing network cables on the LA-PANEL rear side
7.4

Spare parts and recommended tools

Table 3: Available spare parts
RK9U Rack structure with dolly board and 2 coupling bars
SE PLARK9U Dolly board
SE RIGRK9U 2 Coupling bars
MP RK9UPORTE LEXAN
CA RKLOC LEXAN
CA RK9UCACHE 1U blank panel
RKENTR Spacer to fix the LA8 rear part to the LA-RAK
LA8/LA8 US/LA8 JP Amplified controller 4x1800 W @ 4 Ω for EU/USA/ Japan
LAPANEL Analog signal and network distribution panel
LAPANELAES3 Digital signal distribution panel
SE CHPRK9U10 1 m/3 ft XLR cable
SE CHPRK9U03 0.35 m/1 ft XLR cable
CP RK9UETH1 1 m/3 ft CAT5e U/FTP cable
CP RK9UETH2 0.3 m/1 ft CAT5e U/FTP cable
LAPOWER LA-POWER power distribution panel
LARAKBUMP LA-RAK BUMP rigging frame
CA MAN19L
⅝" shackle

In Europe use the LA-POWER device (230 V version) presented all along this manual.
 In USA use the LA-POWER US device (120 V version) presented in Appendix [9].

In any other country contact a local L-ACOUSTICS
IMPORTANT
LARAK_UM_EN_2.0
®
screws back in place (torque to 1.5 N.m/14 in.lb
®
screws back in place into the LA-RAK (torque to 3 N.m/27 in.lb
b. d.
® door
® door latch
w w w . l - a c o u s t i c s . c o m
® screws.
®
screws.
).
f
c.
Table 4: Recommended
tools for service
Torque wrench (N.m or in.lb
PZ.3 Pozidriv
T10 Torx ®
® distributor.
).
f
)
f
screwdriver
®
screwdriver
39