Evaluating Results - Beurer BC 85 Instructions For Use Manual

The measurement is taken during the inflation phase.
You can cancel the measurement at any time by pressing
the START/STOP button
As soon as a pulse is found, the pulse symbol
• The systolic pressure, diastolic pressure
and pulse rate measurements are
displayed.
• E_ appears if the measurement could not be performed
properly. Observe the chapter on error messag-
es/troubleshooting in these instructions for use
and repeat the measurement.
• Now select the desired user memory by pressing
the M1 or M2 memory buttons. If you do not select a user
memory, the measurement is stored in the most recently
used user memory. The relevant symbol M1 or M2 appears
in the display.
• Press the START/STOP button
pressure monitor. The measurement is then stored in the
selected user memory.
®
If Bluetooth data transfer is activated, data is transferred
after pressing the START/STOP button
®
• The Bluetooth symbol flashes on the display. The blood
pressure monitor now attempts to connect to the app for
approx. 30 seconds.
®
• The Bluetooth symbol stops flashing as soon as a connec-
tion is established. All measurement data is automatically
.
is displayed.
to switch off the blood
.
transferred to the app. Once the data has been successfully
transferred, the device switches off.
• If a connection to the app cannot be established after
30 seconds, the Bluetooth
pressure monitor switches off automatically after 3 minutes.
If you forget to turn off the device, it will switch off automati-
cally after approx. 3 minutes. In this case too, the value is
stored in the selected or most recently used user memory.
Wait at least 5 minutes before taking another
measurement.

6. Evaluating results

Cardiac arrhythmia:
This device can identify potential disruptions of the heart
rhythm when measuring and if necessary, indicates this after
the measurement with the symbol
This can be an indicator for arrhythmia. Arrhythmia is an illness
in which the heart rhythm is abnormal because of flaws in the
bioelectrical system that regulates the heartbeat. The symp-
toms (skipped or premature heart beats, pulse being slow or
too fast) can be caused by factors such as heart disease, age,
physical make-up, excess stimulants, stress or lack of sleep.
Arrhythmia can only be determined through an examination by
your doctor.
If the symbol is shown on the display after the measure-
ment has been taken, repeat the measurement. Please ensure
that you rest for 5 minutes beforehand and do not speak or
move during the measurement. If the symbol
quently, please consult your doctor. Self-diagnosis and treat-
26
®
symbol goes out and the blood
.
appears fre-