Operation & Features; Step By Step Diagram - Windster WSC-4630SS User Manual

OPERATION & FEATURES
14
OPERATION & FEATURES
1.
EASY ACCESS CONTROL SWITCH (from left to right)
a. Button 1 – Lights ON/OFF
b. Button 2 – Decrease speed
c. Button 3 – Increase speed
d. Button 4 – Power ON / Delay Shutoff / OFF
2.
GU10 LED 5W LIGHT FIXTURES
a. A set of (2) GU10 5W LED light fixtures will be included.
b. Additional GU10 LED lamps may be purchased separately at your local
hardware store.
c. Light socket can accommodate both halogen and LED lamps without the
needing to change the transformer.
3.
REPLACING LIGHT SET
**NOTE: BE SURE THE LIGHTS ARE NOT HOT
* Use maximum of GU10 5W LED light bulb *
a. Twist outer light ring counter clock wise with light key.
b. Outer light ring should drop down along with the light bulb.
c. Slightly pull the light away from the ring.
d. Move light to left or right side of the ring.
e. Twist light bulb counter clock wise to release it.
f. Replace light bulb.
Electrical Shock Hazard
Warning: To avoid electrical shock, replacement GU10 bulbs MUST
contain UL or CSA certification.
**STEP BY STEP DIAGRAM ON NEXT PAGE

STEP BY STEP DIAGRAM

Using the light fixture tool provided, lineup each
corner of the fixture tool in parallel with the notches
located on the outer ring of the light fixture. Twist
the outer ring counter clockwise to unlock the
light fixture housing.
WARNING!!!
Check to make sure all power sources are disconnected
before starting any troubleshooting. Safety gloves and
glasses should be worn when working on the unit. Serious
injury or death may occur if safety precautions are not
followed.
Light Fixture Tool
Step 1
Twist light ring counter-
clock wise to unlock.
Step 2
Pull the light upward.
Step 3
Push light to left or
right side.
Step 4
Remove the light by turning
light counter-clock wise
15